6.5 Setting Variables

To set a variable from the makefile, write a line starting with the variable name followed by ‘=’ or ‘:=’. Whatever follows the ‘=’ or ‘:=’ on the line becomes the value. For example,

objects = main.o foo.o bar.o utils.o

defines a variable named objects. Whitespace around the variable name and immediately after the ‘=’ is ignored.

Variables defined with ‘=’ are recursively expanded variables. Variables defined with ‘:=’ are simply expanded variables; these definitions can contain variable references which will be expanded before the definition is made. See section The Two Flavors of Variables.

The variable name may contain function and variable references, which are expanded when the line is read to find the actual variable name to use.

There is no limit on the length of the value of a variable except the amount of swapping space on the computer. When a variable definition is long, it is a good idea to break it into several lines by inserting backslash-newline at convenient places in the definition. This will not affect the functioning of make, but it will make the makefile easier to read.

Most variable names are considered to have the empty string as a value if you have never set them. Several variables have built-in initial values that are not empty, but you can set them in the usual ways (see section Variables Used by Implicit Rules). Several special variables are set automatically to a new value for each rule; these are called the automatic variables (see section Automatic Variables).

If you’d like a variable to be set to a value only if it’s not already set, then you can use the shorthand operator ‘?=’ instead of ‘=’. These two settings of the variable ‘FOO’ are identical (see section The origin Function):

FOO ?= bar

and

ifeq ($(origin FOO), undefined)
FOO = bar
endif

This document was generated by Davide Tacchella on November 3, 2010 using texi2html 1.82.